Website: www.OzoneSolutions.com
Email: support@ozonesolutions.com
Phone: (712) 439-6880
Hours: 8 AM - 5 PM Central Time

Is medical O2 different than the other O2 sources?

Ambient air consists of many gasses, but of that mix, only 19% of it is oxygen.

Many applications will require a higher percentage than the 19%. That's where Concentrated Oxygen fills the need. Concentrated Oxygen refers to oxygen which is a minimum of 90% pure with moisture removed to a -100 deg F dew-point. It can be produced from an oxygen concentrator or delivered in a pressurized cylinder bottle.
There are a few methods used to produce the concentrated oxygen;

Pressure Swing Adsorption (PSA)
This system operates on a similar principle to the heat less desiccant dryer in that air is pressure fed to a molecular sieve. The selected media will be pressurized to then adsorb nitrogen, moisture, hydrocarbons, and CO2, leaving oxygen to flow through. When the pressure is reduced, the vapor, nitrogen, and other gases are dispersed and removed by the purged gas. The product gas contains about 90-95% O2 and a few percent each of nitrogen and argon. (Most small oxygen concentrators use the PSA method.)
Other methods of on-site oxygen generation include vacuum swing adsorption and cryogenic treatment which will not be addressed.

All concentrated oxygen is really the same and needs to be generated from oil-free compressors/liquefiers because any oil (of whatever nature) is highly flammable in 100% oxygen.
The difference between the four various oxygen grades, (Aviation, Medical, Welding and Research) is not in the quality of the oxygen but rather, the custody chain of the tanks.
Here's the issue: If a welding tank is used, but it's a rotated or swapped out tank, you will not know if the tank has been left open allowing contaminants to enter the tank. To then use that tank for medical applications would not be good, as impurities could be expelled from the tank.

A solution is: Buy a new oxygen tank, tag it in some manner, and when you get it filled/refilled, demand your personal tank back. You will then establish a chain of custody. The oxygen can be considered medical grade because you started with a clean tank having no contaminants. Because oxygen is considered to be a prescription drug, the FDA is enforcing the chain of custody for the protection of the patients who need bottled oxygen. Companies that fill/refill Medical bottles need to be registered with the FDA and will need to comply with cGMP parts 210 & 211. Currently, the cGMP regulations require the company that fills the cylinders to either own the cylinders or to have written permission of the owners of the oxygen cylinders. Proper pre-fill inspections, labeling, and testing are also required.

If you are using an oxygen concentrator and that machine is being properly inspected and maintained, such as replacing the air compressor air filter(s), and periodically checking its oxygen output purity with an oxygen meter:
http://www.ozonesolutions.com/products/Ozone-Rental-Products/Oxygen-Meter-Rental_Accurate_Oxygen_Tester
That machine will be producing the same grade of oxygen as bottled oxygen.

If you are switching oxygen bottles as I listed above, then you are susceptible to impure oxygen due to the contaminants entering the tank. If you want purer oxygen, maintain the chain of custody!

Last Updated: July 29, 2014

The above information is from http://www.OzoneSolutions.com and is copyrighted by Ozone Solutions Inc.
Jump To TopOzone Solutions Inc. | (712) 439-6880Jump To Top

8 AM - 5 PM Central Time
Phone: (712) 439-6880
Toll Free: (888) 892-0303 (USA Only)
Fax: (712) 439-6733
Email: support@ozonesolutions.com
CLOSE WINDOW